articles

Is a Gasifier a True Alternate Energy Source?

Heating wood or other organic matter in a gasifyer is done to liberate the volatile elements inside the wood. These gasses when released can be used for heating, or ignited in an internal combustion engine to make power. The simplest element of the gasifyer is that is a canister that is insulated to hold in the heat.

A small bed of burning fuel is held within a container inside the drum. The bed of fuel is forced to combust under controlled conditions, by limiting the amount of air, and starts the gas production.

The whole process can be self contained.

This pocket-sized controlled fire is exactly what is needed to allow the gasses to be released uniformly. This heat is used to dry and heat up the fuel stock, so that when it falls into the fire grating, it will readily burn. Ideally the fire should make approximately 1200 degrees F. The red-hot unburned gasses are allowed to escape from the head of the container. The gasses are then cooled and filtered, the cleansing is to cause less damage in an engine, and a denser gas has more power.

The gasifyer then is like a small power station, self contained, but still movable if needed. An oil drum sized producer should be able to operate a modest four cylinder engine, and the gas from a inferior fuel is as good as that from an expensive one.

The types of fuel commonly used will be waste wood chips, chipped branches, coconut waste, rice and corn husks and even battery chicken shed litter. For instance fast growing willow could be used in areas with good water but little commercial waste.

Could this be a fresh source of fuel? Commercial agribusiness needs to pay out cash disposing of large amounts of waste to landfill. And not to overlook the char produced by the gasifyer is a effective soil conditioner and fertiliser, a green bonus?

Using a gasifyer will significantly reduce house hold expanses, even permit off grid living.

The gasses, frequently called syngas or producer gas, can be very clean burning with little or no contamination.

1 gallon of gasoline is said by many to be equal to 20lbs of dry chipped wood. A gasifyer of appropriate size will furnish all the gas to run a particular engine, the bigger the gasifyer the bigger the engine. A gasifyer does not necessarily need any external power nevertheless this will help to start the machine, someone will nonetheless have to fuel the machine. With an internal combustion engine the inductance will draw air through the hearth creating a self sustaining sequence. The Gasifyer.Com.

As a green alternate energy source a gasifyer and petrol generator offers a genuine solution.

Wood Gas Runs Cars

Wood gas is a fuel that is produced from the process in which the carbon containing material or biomass is converted into gas. As these materials burn in a container known as a gasifier, the end products are soot, solid ash and wood gas. The gas goes through a filtration process where ash tar and soot particles are filtered out. The gas is cooled after which it is directed to an engine where a charge is produced. Wood gas technology can be used to power gasoline cars with normal internal combustion engines if attached with a gasifier.

This was a popular mode of powering vehicles during the Second World War era and was widely used in the various European and Asian countries. During that period, wood and related products were the most used forms of fuel for industrial and domestic use. Part of the reason for the increase in the use of wood gas during Second World War period was the lack of a steady supply of oil. The main reason why wood gas is able to power a car is because internal combustion in an engine is facilitated by vapor and not liquid. Therefore, wood gas which is a clean combustible vapor is able to generate power for and engine. To get optimal use of a wood gas powered car, the wood or coal in the gasifier has to be good quality and free of impurities. A high combustion temperature is needed to produce more gas to the engine.

The rate of efficiency for wood gas systems is high with about 75% of the of fuel content being converted in the gasifier stage. Tests done with a wood gas powered car driven over a distance of 60,000 miles showed the energy consumption to be up to twice the energy demand. It has been proved that the exhaust emission levels for wood gas powered cars are lower than those of internal combustion powered cars. The wood gas is usually produced in transit by a device that is normally installed on the vehicle. This transportable plant can easily be constructed from a steel drum and consists of a generator, a mixing valve and a cleaning apparatus that also acts as a cooler. All these components are interconnected to each other and to the engine of the vehicle through a piping system.

There is an option of adding a fan which could aid the movement of gas. However, this is not actually a necessity considering that the power plant's intake has a suction that is enough to carry the fumes and air through the system. The wood gas generators are simple with the fuel being led by gravity from a hopper and into a combustion compartment. The high temperature experienced in this chamber may require a refractory brick lining or should be double walled with an intervening space for the up take of air. As a precautionary measure against possible fires, a flame trap is necessary at the point of air uptake.

Find the best deal on the auto insurance coverage you need. Visit us today for money-saving tips and receive free auto insurance quotes for the cheapest insurance rates from respected insurance companies.